Programming In 7-Day Mode; Before Change Preset Programmes - Danfoss TP7000 Series User Manual

1.8 Before you change the preset programmes
Your installer will have set your unit to operate in either 7-day mode
or 5/2 day mode. To tell which mode your unit is set press PROG
until Event 1 fl ashes in the display.
1
GB
F
1 2 3 4 5
D

1.81 Programming in 7-day mode

(separate programmes for each day of the week)
ES
a) Press PROG until Event 1 fl ashes, then
DK
press DAY to move from current day to
Day 1.
NL
I
GR
b) Amend the time and temperature as
follows:
PL
i) Use + and – buttons to alter time
(press and hold to change in 10 min
increments).
LT
ii) Use
CZ
temperature in 0.5°C (1°F) steps.
iii) Press NEXT to advance to next
HR
Event.
iv) Repeat steps i,ii & iii above for Events
2, 3, 4, 5 & 6.
c) When all 6 events are correct, press DAY
to programme events for Day 2.
8
This unit is in 7-day mode and you can programme
diff erent settings for each day of the week (see page
8-9).
This unit is in 5/2 day mode and you can enter one of
set of programmes for weekdays and another set for
weekends (see page 91).
and buttons to alter
1
TP7000 RANGE