Changing The Preset Programmes In 7 Day Mode; Changing The Preset Programmes In 5/2 Day Mode; For Weekdays - Danfoss TP9000 Installation And User Instructions Manual

Before beginning programming the unit remember to check that the
correct function is selected i.e. Heating or Hot Water by using the CH/
HW button.

Changing the preset programmes in 7 day mode

a) Press PROG once until the display shows the
fi rst preset time and temperature
b) Use the + and - buttons to adjust the time
(press and hold to adjust in 10 minute increments)
c) Use the Λ and V buttons to adjust the required temperature (CH
only)
d) Press NEXT to move to the next preset time
and/or temperature (Event 2)
e) Once all events for the day have been
programmed, press DAY/HOL to move to the next day
f ) Repeat steps b, c, d & e to programme the remaining weeks
events.
g) Press and hold PROG to return to the main screen.

Changing the preset programmes in 5/2 day mode

For Weekdays

a) Press PROG until the fi rst preset time and
temperature (Event 1 Days MON, TUE, WED,
THU, FRI)
b) Use the + and - buttons to adjust the TIME (press and hold to
change in 10 minute increments).
c) Use the Λ and V buttons to adjust the required TEMPERATURE (CH
only).
DANFOSS HEATING
GB
PL
21