Frequency Setting - Icom IC-718 Instruction Manual

n Frequency setting
D Using the tuning dial
q Push [∫ UP] or [√ DN] one or more times to
select the desired ham band.
w Select the desired operating mode with the mode
switch. (p. 20).
e Rotate the tuning dial to set the desired frequency
D Direct frequency entry with keypad
The transceiver has a keypad for direct frequency
entry as described below.
q Push [F-INP/ENT], then push the numeral keys
on the keypad to enter the MHz digits for the
desired frequency.
• If a key is mistakenly pushed, push [SET] (or any key
except keypad) and start again from the beginning.
• When entering the same MHz digits as the displayed
frequency, this step can be skipped.
[EXAMPLE]
•Start
•To set to 21.025 MHz
2 1
A=B
V/M
•To set to 706 KHz (0.706 MHz)
0
ANF
•To set to 7 MHz
7
SPL
•To change 14.195 to 14.850 MHz
NR
F-INP
ENT
ANF
NR
NR SPL
F-INP
ENT
8 5
SCN
M=CL
• For general coverage receiver use
The IC-718 has a general coverage receiver band.
q Push [∫ UP] or [√ DN] one or more times to
select the general coverage receiver band.
Note: Even if you select the ham band, you can set the
transceiver to the general coverage frequency. When
the displayed frequency exits the transmit frequency
range (ham band), a band edge beep may be emitted
(depends on initial set mode programming).
w Push [•] on the keypad.
e Push the numeral keys to enter the frequency
digits below 1 MHz.
• If a key is mistakenly pushed, push [SET] (or any key
except keypad) and start again from the beginning.
r Push [F-INP/ENT] to set the input frequency.
• When pushing [F-INP/ENT] after entering the MHz
digits, zeros are automatically entered for the kHz digits.
0 2
5
A=B M=CL
7
0 6
ANF
M V
F-INP
ENT

FREQUENCY SETTING

F-INP
ENT
F-INP
ENT
4
17