Icom IC-718 Instruction Manual page 6

2
PANEL DESCRIPTION
n Front panel
AF SQL RIT SHIFT
LOCK
@2 VFO/MEMORY SWITCH/1 [V/M•1] (pgs. 16, 35)
 Toggles the operating mode between VFO
mode or memory mode when pushed.
@3 MEMORY WRITE SWITCH/4 [MW•4] (p. 36)
 Stores the displayed frequency and operating
mode into the selected memory channel when
pushed for 1 sec.
@4 SPLIT SWITCH/7 [SPL•7] (p. 30)
Turns the split frequency operation ON or OFF
when pushed.
@5 NR SWITCH/. [NR• . ] (p. 23)
 Toggles the optional noise reduction function ON
or OFF when pushed. Functions in all modes.
• An optional UT-106 DSP UNIT is required.
• [NR] appears on the display.
 Enters noise reduction level set mode when
pushed for 1 sec.
@6 ANF SWITCH/0 [ANF•0] (p. 23)
 T oggles the Automatic Notch Filter function ON or
OFF. Functions in SSB and AM modes.
• An optional UT-106 DSP UNIT is required.
• [ANF] appears on the display.
@7 FRQUENCY INPUT/ENTER SWITCH
[F-INP/ENT]
 [F-INP/ENT], then keypad then [F-INP/ENT]
— Direct frequency input. (p. 17)
 [CH] then [F-INP/ENT], then keypad then
[F-INP/ENT]. Push [CH].
— Direct memory number selection. (p. 35)
4
(continued)
1
V/M
MODE FILTER TS
4
MW
7
SPL
.
NR ANF
NB
P.AMP
Z
CH DN
2 3
A=B A/B
@2
5 6
M=CL M V
@3
8 9
SCN VOX
@4
0 F-INP
ENT
@5
COMP
SET
ATT TUNER
Y
UP
@8 SCAN SWITCH/8 [SCAN•8] (p. 39)
 Push momentarily to start/stop the programmed
scan in VFO mode.
 Push momentarily to start/stop the memory scan
in memory mode.
@9 VOX SWITCH/9 [VOX•9] (p. 27)
 Turn the VOX function ON or OFF when pushed
in SSB modes.
#0 M≈V SWITCH/6 [MV•6] (p. 37)
 Transfers the memory contents to VFO when
pushed for 1 sec.
#1 MEMORY CLEAR SWITCH/5 [M=CL•5] (p. 38)
 C lears the selected readout memory channel
contents when pushed for 1 sec. in memory mode.
• [BLANK] appears above the memory channel number.
#2 VFO SELECT SWITCH/3 [A/B•3] (p. 16)
 Toggles between VFO A or VFO B in VFO
mode.
 Toggles between transmission VFO and
reception VFO during split operation.
#3 VFO EQUALIZATION SWITCH/2 [A=B•2]
Equalize the frequency and operating mode of the
two VFO's.
• The VFO B frequency and operating mode are equalized
with the VFO A frequency and operating mode.
#3 #2
1 2 3
V/M A=B A/B
#1
4 5 6
#0
MW M=CL M V
@9
7 8 9
SPL SCN VOX
@8
.
0 F-INP
NR ANF
@7
ENT
@6