Icom IC-718 Instruction Manual page 20

4
FREQUENCY SETTING
D Band stacking resister
The band stacking register automatically stores the
last frequency and mode used for each band. This
is convenient for contest operation, etc. The tables
below shows the band stacking register default
settings for each band.
BAND
1.9 MHz
3.5 MHz
7 MHz
10 MHz
14 MHz
General
D Band selection
All HF ham bands and a general coverage receiver
band are included in the IC-718.
Push [∫ UP]/[√ DN] to select the desired band.
• Pushing [∫ UP]/[√ DN] continuously scrolls through the
available bands.
Note: For example, if 6.10000 MHz is resistered as
the General coverage frequency, then the General
coverage band automatically positions itself between
3.5 MHz and 7 MHz band.
D Programmable tuning steps
Programmable tuning steps are available to suit your
operating requirements.
These tuning steps are:
• Selectable from 0.1, 1, 5, 9, 10, 100 kHz
q Push [TS], the programmable tuning step indicator,
"," then appears above the 1 kHz.
• Rotating the tuning dial changes the frequency
according to the set tuning step.
w Push [TS] for 2 sec. while the programmable
tuning step indicator appears to enter the tuning
step set mode.
e Rotate the tuning dial to set the desired tuning
step.
r Push [TS] to exit the tuning step set mode.
t Rotate the tuning dial to change the frequency
according to the set tuning step.
18
BAND BAND
1.91000 MHz CW
3.55000 MHz LSB
7.05000 MHz LSB
10.12000 MHz CW
14.10000 MHz USB
15.10000 MHz USB
BAND BAND
18 MHz 18.10000 MHz
21 MHz 21.20000 MHz
24 MHz 24.95000 MHz
28 MHz 28.50000 MHz
29 MHz 29.50000 MHz
Z DN
General (new)
BAND
USB
USB
USB
USB
USB
UP Y
General (old)
Programmable tuning
step indicator
10 KHz tuning steps is
selected.