Explicit Definitions; Precautions - Icom IC-718 Instruction Manual

IMPORTANT
READ THIS INSTRUCTION MANUAL
CAREFULLY
before attempting to operate the
transceiver.
SAVE THIS INSTRUCTION MANUAL.
manual contains important safety and operating
instructions for the IC-718.

PRECAUTIONS

R WARNING HIGH VOLTAGE! NEVER
attach an antenna or internal antenna connector
during transmission. This may result in an electric
shock or burn.
R NEVER
apply AC to the [DC13.8V] jack on the
transceiver rear panel. This could cause a fire or ruin
the transceiver.
R NEVER
apply more than 16 V DC, such as a 24
V battery, to the [DC13.8V] jack on the transceiver
rear panel. This could cause a fire or ruin the
transceiver.
R NEVER
let metal, wire or other objects touch
any internal part or connectors on the rear panel of
the transceiver. This may result in an electric shock.
NEVER
expose the transceiver to rain, snow or any
liquids.
AVOID using or placing the transceiver in areas with
temperatures below –10°C (+14°F) or above +60°C
(+140°F). Be aware that temperatures on a vehicle'
s dashboard can exceed 80°C (+176°F), resulting in
permanent damage to the transceiver if left there for
extended periods.
AVOID placing the transceiver in excessively dusty
environments or in direct sunlight.
AVOID placing the transceiver against walls or putting
anything on top of the transceiver. This will obstruct
heat dissipation.
i

EXPLICIT DEFINITIONS

WORD
R WARNING
This
CAUTION
NOTE
During mobile operation, DO NOT operate the
transceiver without running the vehicle's engine.
When transceiver power is ON and your vehicle's
engine is OFF, the vehicle's battery will soon become
exhausted.
Make sure the transceiver power is OFF before
starting the vehicle. This will avoid possible damage
to the transceiver by ignition voltage spikes.
D u r i n g m a r i t i m e m o b i l e o p e ra t i o n , ke e p t h e
transceiver and microphone as far away as possible
from the magnetic navigation compass to prevent
erroneous indications.
BE CAREFUL! The heatsink will become hot when
operating the transceiver continuously for long
periods.
BE CAREFUL! If a linear amplifier is connected, set
the transceiver's RF output power to less than the
linear amplifier's maximum input level, otherwise, the
linear amplifier will be damaged.
Use Icom microphones only (supplied or optional).
Other manufacturer's microphones have different
pin assignments, and connection to the IC-718 may
damage the transceiver.
DEFINITION
Personal injury, fire hazard or electric
shock may occur.
Equipment damage may occur.
Inconvenience only.
No risk of personal injury, fire or
electric shock.