Selecting An Input; Setting The Front Panel Lockout Mode (Executive Mode); Enabling Auto Switch Mode; Enabling Normal Switch Mode - Extron electronics XTP T USW 103 User Manual

Selecting an Input

To select an input from the front panel, perform the following actions:
Press the input selection button that corresponds with the desired rear panel input
connector. The corresponding LED lights to indicate the active input.

Setting the Front Panel Lockout Mode (Executive Mode)

Push and hold (for about 5 seconds) inputs 1, 2, and 3 simultaneously until all front panel
LEDs blink three times to enable or disable front panel configuration.
In executive mode, input selection from the front panel is disabled, but RS-232 control and
contact closure are still available.

Enabling Auto Switch Mode

Press and hold (for about 3 seconds) inputs 1 and 3 simultaneously until the Auto Switch
LED lights. In auto switch mode, the switcher automatically switches to the highest
numbered input with an active video signal.
NOTE:
done only with SIS commands (see
Normal switch mode is the default switch mode.
The audio input selected depends on the audio input selection setting (see
selection

Enabling Normal Switch Mode

Press and hold (for about 8 seconds) inputs 1 and 2 simultaneously until the Auto Switch
LED turns off. This is the default switch mode.

EDID

To manage EDID on the XTP T USW 103, use the XTP System Configuration Software
(see XTP System Configuration Software
Configuration and
in a user memory location, select a pre-defined EDID, or use EDID from a display connected
to a receiver. EDID stored in the user memory location can come from the display connected
to a receiver or a custom EDID imported through the XTP System Configuration Software.
NOTE:
using the XTP System Configuration Software.
Setting auto switch mode to prioritize the lowest numbered active input can be
SIS commands on page 15).
Control on page 13). The XTP T USW 103 can record and save EDID
In matrix applications, EDID on the switcher is assigned by the matrix switcher
Auto switch mode
SIS commands on page 15).
on page 18) or SIS commands (see
XTP T USW 103 • Operation
Audio input
SIS
11