Extron electronics XTP T USW 103 User Manual page 10

c
HDMI connectors — Connect a digital video source device to either or both female
HDMI connectors, labeled inputs 2 and 3. They can accept HDMI, DVI, or dual mode
DisplayPort video sources.
d
XTP connector — Connect a twisted pair cable to the RJ-45 connector labeled
XTP Out and the XTP input port on another XTP device to pass all signals (see
TP Cable Termination and Recommendations
following signals:
Digital video
•
Digital audio
•
Bidirectional RS-232 and IR commands
•
Remote power
•
Ethernet communication
•
System communication
•
The LINK LED lights yellow when XTP devices are connected and communication is
established.
The SIG LED lights green when the transmitter outputs a video signal or a test pattern.
ATTENTION:
• Do not connect this connector to a computer data or telecommunications
network.
• XTP remote power is intended for indoor use only. No part of the network that
uses XTP remote power should be routed outdoors (see
page 9).
e
LAN connector — Connect a control device or device to be controlled to this LAN
connector for 10/100 Ethernet communication through this pass-through port. LEDs on
this connector indicate link and activity status.
f
RS-232 Over XTP port — To pass bidirectional serial or other control signals
between XTP-compatible devices, connect a control device to the 5-pole
captive screw connector. The port includes only the 3 poles labeled
"RS-232."
IR Over XTP port — To transmit and receive IR signals (up to 40 kHz),
connect a control device to the 5-pole captive screw connector. This port
only includes the 2 poles labeled "IR" and shares the ground pole with the
RS-232 port.
NOTE: RS-232 and IR data can be transmitted simultaneously (see
Communication
on page 7 for wiring details).
g
Contact closure connector — Connect an Extron KP 6 or similar device to the 3.5
mm, 4-pole captive screw connector. The first three ports are used for selecting inputs
1 through 3 when momentarily shorted to the ground port.
h
RS-232 connector — Connect a host device to the 3.5 mm, 3-pole captive screw
connector for serial control of the switcher.
i
Power connector and LED — Connect an external power supply to the 3.5 mm,
2-pole captive screw connector (see
lights to indicate the device is receiving power.
NOTE: The XTP T USW 103 can be powered remotely (see
page 9).
on page 6). This cable carries the
Remote power
Power Connection on page 8). The Power LED
Remote power
XTP T USW 103 • Installation
on
RS-232 IR
Tx Rx G Tx Rx
RS-232 IR
Tx Rx G Tx Rx
RS-232 and IR
on
4