Battery-Backed Write Cache Battery Pack Option - HP ProLiant ML310 Generation 5p User Manual

Power down the server (on page 16).
1.
Unlock the bezel (on page 17).
2.
Remove the access panel (on page 18).
3.
Remove the expansion slot cover that corresponds to the parallel and serial connector
4.
expansion slot
Install the parallel and serial connector bracket.
5.
Connect the parallel and serial cables to the parallel and serial connectors on the system board.
6.
Close the PCI retainer.
7.
Install the access panel (on page 18).
8.
Lock the bezel.
9.
Power up the server (on page 16).
10.
Enable the feature under the System Options menu in RBSU. For more information on RBSU, refer to the
11.
HP ROM-Based Setup Utility User Guide on the Documentation CD or the HP website
(http://www.hp.com/servers/smartstart).

Battery-backed write cache battery pack option

CAUTION:
the battery pack while an array capacity expansion, RAID level migration, or stripe size migration
is in progress.
CAUTION:
before unplugging the cable from the cache module. If the amber LED blinks after 15 seconds, do
not remove the cable from the cache module. The cache module is backing up data, and data is
lost if the cable is detached.
cover" on page 38).
To prevent a server malfunction or damage to the equipment, do not add or remove
After the server is powered down, wait 15 seconds and then check the amber LED
("Removing the
Hardware options installation 42