Assembling Deep Cleaner - Hoover Ultra User Manual

Assembling
Deep Cleaner
The assembled cleaner will look like this
drawing (Ultra model shown).
4
Place nuts in recessed areas on
4
back of handle. Hold each nut in
place while tightening each bolt securely
with a Phillips screw driver.
Only two nuts are needed on this model.
The extra nut is not required but has
been provided for your convenience.
7
Press cord into cord clip on back of
7
handle. Pull cord tight.
4
2
Attach upper handle
Remove clean solution tank (upper
2
tank) from deep cleaner.
5
When handle sections are complete-
5
ly together, squeeze trigger (B) on
upper handle to snap trigger rod In
place.
8
Attach hose clip
Push tab on side of clip into hole on
8
side of handle.
3
With cord hook (A) to back of deep
3
c l e a n e r, push upper handle down onto
lower handle. Push b o l t s into holes on
f ront of handle. If bolts will not go
t h rough hole easily handle is not pushed
c o m p l e t e ly dow n .
6
B
Replace clean solution tank (upper
6
tank) by positioning bottom first.
Press on tank handle to snap top of
tank into place.
9
Pivot clip and push other tab into
9
hole at back of handle to lock into
place.
A