Assembling Deep Cleaner - Hoover SteamVac F5875900 Owner's Manual

The assembled cleanerwill look
like
this
drawing(Ultra model shown).
Attach upper handle
[_ Removeclean solutiontank (upper
tank) from deep cleaner.
B
W_h cordhook (A)tobackofdeep
r,p_d_upperhandledownor=to
lowerhandle.Pushbolts hto kolesoo
front of handle.If bolts will not go
UvoughholeeasUy handle is notpushe_
_n_pletely down.
[-_-| Placenuts in recessed areas on
back of handle. Hold each nut in
place while tighteningeach bolt securely
with a Phillipsscrewdriver.
Only two nuts are neededon this model,
The extra nut is not requiredbut has
been providedfor your convenience.
ILl When handlesections are complete-
ly together,squeeze trigger(B) on
upper handleto snap triggerrod In
place,
II_Replace clean solutiontank (upper
tank) by positioningbottomfirst.
Presson tank handleto snap top of
t_ into place.
[]Press cord into cord clip on back of Attach hose clip
handle. Pull cord tight.
[_ Pushtab on side of clip into holeon
side of handle.
_ Pivot clip and push other tab into
hole at back of handle to lock into
place.