Hoover Twin Chamber Service Instructions Manual
  1. Manuals
  2. Brands
  3. Hoover Manuals
  4. Vacuum Cleaner
  5. Twin Chamber
  6. Service instructions manual

Hoover Twin Chamber Service Instructions Manual

Hide thumbs

Advertisement

Table of Contents

SERVICE INSTRUCTIONS
,HOOVER - BAGLESS
CLEANERS
o41oo
149 E -1

Advertisement

Table of Contents
loading

Related Manuals for Hoover Twin Chamber

Summary of Contents for Hoover Twin Chamber

  • Page 1 SERVICE INSTRUCTIONS ,HOOVER - BAGLESS CLEANERS o41oo 149 E -1...

  • Page 2: Exploded View

    Handle Cap Upper Handle Handle Cover Rear Di_ Cup_ HEPA Front Cover pport Latch Shaft Spring Pre-Filter __ Rear Filter Grille Dirt Cup _ Front Cover Housing rool Rack @ Hood " Lens Seal Motor Rear Axle Lamp Nozzle Height Cam Actuator •...

  • Page 3: Product View

    I. General The carpet height adjustment lever has 4 settings for carpet cleaning and one for top tool conversion. The Hoover Twin Chamber Bagless upright cleaners were first introduced in mid - 2000. The initial line consisted of three models.

  • Page 4: Disassembly

    III. Disassembly A. Twin Chamber Dirt Cup Assembly 1. Remove Dirt Cup Assembly by lifting Dirt Cup Latch and sliding Dirt Cup out of position as illustrated. 2. To remove the Pre-Filter and HEPA filter putt straight upward on the Pre-Filter Assembly while slightly flexing the dirt cup outward as shown.
  • Page 5 E. Upper Handle Assembly 1. Pry out ward on back panel of Upper Handle to release tabs on back of handle as shown. While prying )ull handle up to release from cleaner. 4. To remove handle cover, pry handle cover as shown and pull forward out of position.
  • Page 6 3. Once the Lower Handle has been removed from the H. Switch Control I Rear Cover base of cleaner the Attachment Cord can be lifted out of Lower Handle and replaced. 1. Remove 1 screw inside lower cord hook. Note: The attachment cord has a small bump located on the end of the plug.
  • Page 7 J. Hood L. Bottom Plate 1. Remove height adjustment lever. 1. Turn cleaner upside down. 2. Remove four screws securing bottom plate. Height Adj Lever 2. Remove four screws as illustrated 3, Lift bottom plate up and off of unit. M.
  • Page 8 O. Hose 1, Remove four screws securing L.H. motor retainer, The spring on the cam is replaceable. R. Rear Wheels. 1. Release the rear wheel shaft from the main body retention slots. 2. Hose can be removed from motor retainer by releasing two tabs from under side of retainer.
  • Page 9 Motor Assembly 5. Lift off fan chamber and remove fan (LH thread) 1. Remove handle. At this point, you have broken a latex paint seal between the motor housing and fan chamber cover. It is important 2. Remove hood. that aluminum tape be installed in its place as shown below.
  • Page 10 6. Remove field winding lead from switch terminal by uncrimping connection. 7. Remove switch by releasing switch pressure tabs and snapping switch out of holder. Note: When installing a new switch, the field winding lead must be securely crimped to the proper switch terminal. 04100 149 E -10...

  • Page 11: Troubleshooting

    Troubleshooting check list - Hoover Bagless Cleaner The following is a guide to aid in determining the origin of a problem for which these models could conceivably be brought in for service. PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION A, Motor won't 1, Not firmly plugged in.
  • Page 12 PARTS USER DEALER SEARS U5288-900 32541004 $0.62 $0.42 $0.28 LATCH SHAFT 36153064 $2.34 $1.56 $1.03 LATCH - DIRT CUP 36153065 $1.87 $1.25 $0.83 LATCH SUPPORT 36426043 $5.20 $3.43 PRE FILTER $7.80 36433145 $13.62 $9.10 $6.01 TOOL RACK $O.55 36923011 $1.25 $0.83 TOOL RACK GUIDE 37245037...

This manual is also suitable for:

Twin chamber u5288-900

Table of Contents