Lighting Instructions - Napoleon PTH31GT Instructions Manual

Bellagio commercial gas patio heater
Hide thumbs Also See for PTH31GT:
Table of Contents

Advertisement

Lighting Instructions

WARNING!
Never use the heater while it is raining, the glass tube could crack or break causing serious
injury.
WARNING!
Ensure burner controls are in the off position. Slowly turn on the gas supply valve.
1. Turn burner control to 'LIGHT'
position.
2. Press and hold igniter button until
pilot lights, or light by match.
(check for pilot flame through glass
tube)
3. Once pilot is lit, keep control knob
depressed for 15 seconds and then turn
control knob to 'LOW'.
4. If ignition is not immediate, turn
burner control off. Wait 5 minutes.
Repeat.
5. For maximum heat turn control knob
to 'HIGH'
6. To turn off the patio heater, turn the
control knob to the 'OFF'
and then turn the gas supply off at the
source.
WARNING!
The propane cylinder is equipped with an excess flow device. Unless burners are turned
off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
If lighting the unit with a match, clip the match into the supplied lighting rod.
Hold the lit match through the hole in the bottom or front of the control box while turning the
burner valve to high.
Lighting Holes
position
7
www.napoleongrills.com

Advertisement

Table of Contents
loading

Table of Contents