Summary of Contents for Napoleon PTH38PSS, PTH38PCP, PTH38PGM
Page 1
PATIO HEATER Manual,Instructions & Parts List -PTH38PSS- -PTH38PCP- -PTH38PGM- WARNING: For Outdoor Use Only. FOR YOUR SAFETY If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. if odor continues ,immediately call gas supplier.
DANGER WARNING: Improper installation, adjustment, alteration, services or maintenance can cause injury, death or property damage. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment. WARNING For outdoor use only. Cylinders to be used must be constructed and marked in accordance with US DOT specifications.
Page 3
Center Reflector Cap Reflector Cap Head Assembly Gas Hose Post Cylinder Cover Post Mounts Cylinder Base 15 M6 Nuts 18 6mm Washers 5mm Washers 4mm Washers M4 8 Bolts M5 8 Bolts 12 M6 10 Bolts M6 x70 double pointed bolts Regulator Cylinder (Not Supplied) PARTS...
Page 4
NOTE: PLEASE READ THE FOLLOWING SAFETY RULES WARNING This appliance must only be used outdoors. Using this product in an enclosed area may cause injury, death or property damage. Read the instructions before use. This appliance must be installed in accordance with such regulations as are in force.
WARNING: TO BE INSTALLED ONLY BY AN AUTHORISED PERSON Instruction For Battery Installing Upon first time use of the product,please remove the ignition button and install an AAA battery as indicated. ASSEMBLY FOR LIGHT SYSTEM ASSEMBLY FOR LIGHT SYSTEM Ignition button Replace Battery Ignition button AAA battery...
Page 6
NOTE: Assembly of this heater requires basic mechanical skills. Proper assembly is the responsibility of the installer. Step 1 ---- Attach Post to Base Assembly Attach the post to the post mounts using M5 X 8 bolts (6 pcs) and 5mm washers (6 pcs) Step 2 ---- Attach Cylinder Cover to Post Mounts Attach the cylinder cover to the post mounts.
Page 7
NOTE: Assembly of this heater requires basic mechanical skills. Proper assembly is the responsibility of the installer. Step 3 ---- Attach Head Assembly to Post Load head assembly by inserting gas hose into post. Insert head assembly into post. Tighten securely using M4 X 8 Bolts (5 pcs) and 4mm washers (5 pcs).
Page 8
NOTE: Assembly of this heater requires basic mechanical skills. Proper assembly is the responsibility of the installer. Step 5 ---- Attach Center Reflector to Reflector Attach center reflector to the top of reflector (4 pcs) by M6 X 10 mm screws (12 pcs) , 6mm washers (12 pcs) and nuts (12 pcs).
Page 9
Attach regulator to cylinder. Tighten securely. Move cylinder to the plate of base assembly. Step 8 ---- Check for leak Your Patio Heater has been checked at all factory connections for leaks, To check the Connection of the gas hose/regulator/cylinder.
Page 10
WARNING : TO BE INSTALLED ONLY BY A COMPETENT PERSON Step 9---- Lower Cylinder Cover onto Cylinder Base Lower the cylinder cover onto the cylinder base . Step 10---- Disconnect Cylinder When Storing or Transporting 1).Turn off the heater; 2).Upper the cylinder cover onto the post mounts; 3).Turn off the valve of the cylinder;...
WARNING: DO NOT attempt to operate heater until you have read and understand all precautions. Failure to do so can result in serious personal injury, death or property damage. Before Turning Gas Supply ON Your heater was designed and approved for OUTDOOR USE ONLY. Do NOT use it inside a building ,or any other enclosed area.
Before Leaving 1)Turn the control knob to "OFF" position and Turn LP cylinder to "OFF" position. 2)Never leave the patio heater unattended while in use. SHUT DOWN INSTRUCTIONS 1) Push in and turn control knob clockwise to "OFF" position. 2) Turn L.P. tank gas valve clockwise to "OFF" position when heater is not in use Note: After use, some discoloration of the emitter screen is normal.
BE CAREFUL WHEN CERTAIN MATERIALS OR ITEMS ARE LEFT, ABOVE, BESIDE OR UNDER THIS HEATER WHILE IN USE, THEY WILL BE SUBJECT TO RADIANT HEAT AND COULD BE SERIOUSLY DAMAGED. This heater is primarily used for the heating of outdoor patios, decks, spas, pool and open working areas.
MAINTENANCE : To enjoy years of outstanding performance from your heater make sure you perform the following maintenance activities on a regular basis: Keep exterior surfaces clean. Use warm soapy water for cleaning. Never use flammable of corrosive cleaning agents. While washing your unit, be sure to keep the area around the burner and pilot assembly dry at all times.
PROBLEM Pilot will not light Pilot will not stay on Burner will not light PROBABLE CAUSE Gas valve may be OFF Fuel Tank empty Orifice blocked Air in supply system No Battery Debris around pilot Loose connection Thermocouple bad Gas leak in line Lack of fuel pressure Pressure is low Orifice blocked...