Advertisement
Quick Links
TERRACE AND PATIO HEATER
USER INSTALLATION AND OPERATION
GUIDE
INDEX
General and specifications ...................1,2
Security and caution .......................... 3
Tools and accessories required ............ 5
Assembly instructions ........................ 5 - 7
Operation (Lighting Instruction) ............ 9
Parts available to order ..................... 10
Warranty info
Carefully read this guide and all safety information
before assembling and setting up the heater
THIS APPLIANCE IS APPROVED
FOR OUTDOOR USE ONLY
Napoleon Appliance Corporation
214 Bayview Dr., Barrie, Ontario, Canada L4N 4Y8
Phone: 1-705-726-4278
Fax: 1-705-725-2564
Customer service: 1-866-539-2039 or
wecare@napoleonproducts.com
Advertisement
Related Manuals for Napoleon PTH55PSS-1
Summary of Contents for Napoleon PTH55PSS-1
- Page 1 Carefully read this guide and all safety information before assembling and setting up the heater THIS APPLIANCE IS APPROVED FOR OUTDOOR USE ONLY Napoleon Appliance Corporation 214 Bayview Dr., Barrie, Ontario, Canada L4N 4Y8 Phone: 1-705-726-4278 Fax: 1-705-725-2564 Customer service: 1-866-539-2039 or...
- Page 2 READ SAFETY REQUIREMENTS BEFORE OPERATION 1. The installation must conform with local codes or in the absence of local codes, with either the National Fuel Gad Code, ANSI Z223.1, or CSA B149.1, Propane Installation Code. 2. This outdoor gas appliance is not intended to be installed in or on recreational vehicles and/or boats.
- Page 3 WARNING: 1. Children and adults should be alerted to the hazards of high surface temperature and should stay away to avoid burns or clothing ignitions. 2. Young children should be carefully supervised when they are in the area of the heater. 3.
- Page 4 the manufacturer. 6. The cylinder must be provided with a shutoff valve terminating in an LP-gas supply cylinder valve outlet specified, as applicable, for Connection No. 510 in the Standard for Compressed Gas Cylinder Valve Outlet and Inlet Connections, ANSI/CGA-V-1. 7.
-
Page 5: Parts List
CAUTION ● Faulty installation, modifications, repairs or maintenance to the appliance may be the cause of injury or damage to property. ● Carefully read this User Guide before assembling and setting up the heater. ● Keep this guide for future reference. ●... - Page 6 TOOLS AND EQUIPMENT REQUIRED 10 and 13mm wrench, Philips screwdriver, medium blade Leak test solution: MIX 50/50 water and soap 1 Propane cylinder (not supplied), with QCC 1 valve Attention: Please start to assemble wheel set first before assembling complete unit.
- Page 7 Fasten post to the vertical supports Slide cylinder cover on post. with 6 bolts M6 X 35 and 6 nuts M6. Before assembling the burner head on post, please fix the 3 supported brackets onto burner head for assembling reflector Slide hose through bottom of post and connect to burner head.
- Page 8 Assemble the reflector pieces to the middle piece using the small washers and the acorn nuts. Place a steel washer over each bolt on the burner top (figure 8) Lay reflector over the burner top bolts add another steel washer to each bolt. Install a full gas cylinder on the base.
- Page 9 If you detect bubbles, there is a leak. Close cylinder valve completely. Retighten the leaking connection and repeat leak test process. If the leak cannot repaired permanently, close cylinder valve completely and contact the customer service department at 1-866-539-2039 or a qualified gas technician. A SAFE LOCATION FOR THE HEATER CAUTION When objects are left under a heater in operation, they will be subject to radiant heat...
- Page 10 OPERATION TO LIGHT： 1. From ‘OFF’ position, depress knob, turn 90° counter-clockwise and hold. 2. Press the igniter until flame is established. 3. Release the knob and check that the flame stays lit. 4. If the flame goes out, wait 5 minutes then repeat steps 1 & 2 above. 5.
- Page 11 PARTS AVAILABLE TO ORDER...
-
Page 12: Limited Product Warranty
Any work or repair of this product must be performed by qualified service personnel. The warranty period is not extended by the repair or replacement. Napoleon Appliance Corporation is not responsible for the installation, labor or any other expenses associated with the re-installation of a warranted part.