Use Energy Saving Features - Synology DiskStation User Manual

Note: The NTP service is required for Surveillance Station. Therefore, if you have Surveillance Station installed and
run on your DiskStation, the service cannot be disabled while the package is running.

Use Energy Saving Features

Go to Main Menu > Control Panel
General
Click the General tab to set up power recovery or Wake on LAN (WOL)
To enable the power recovery function:
1 Tick Restart automatically after a power
power failure, ticking this option will boot up DiskStation automatically after power has been restored.
2 Click Apply.
To enable Wake on LAN:
1 Tick Enable Wake on LAN
2 Click Apply.
About Wake on LAN: After Wake on LAN is enabled for your DiskStation, you can turn on Synology DiskStation
over the local area network or the Internet by using a WOL (Wake on LAN) application. Activate the function by
entering DiskStation's IP address (or DDNS hostname) and MAC address.
Wake on LAN works only after Synology DiskStation is shut down properly by pressing the
selecting Shutdown from DSM's Main Menu, and its power cord is plugged into a working power outlet.
Note: You can also perform Wake on LAN for supported Synology DiskStation with Synology Assistant. See the
Help of Synology Assistant for more information.
---------
1
Wake on LAN is supported on specific models only. Visit
24 Chapter 3: Modify System Settings
> Power to manage the following energy saving features provided by DSM.
failure. If the DiskStation was shut down abnormally due to a
(or Enable WOL on LAN [number]
More Information
www.synology.com
Synology DiskStation User's Guide
1
, or conduct FAN controls.
for DiskStations with multiple LAN ports).
Power
for more information.
Based on DSM 4.1
button or