Synology DiskStation User Manual page 25

To control fan speed:
1 Choose the appropriate fan speed mode according to your need
mode), or according to the size of your hard disks
on the DiskStation models you are using.
2 Click Apply.
Cool Mode or 3.5" hard disk mode
can further reduce the noise level.
Beep Control
Click the Beep Control tab to have DiskStation play beep sounds under certain circumstances.
To manage beep control:
Tick or uncheck the checkboxes and click Apply.
UPS
Under the UPS tab, you can enable UPS support to prevent data loss when an unexpected power failure occurs.
To enable local UPS support:
1 Connect a local UPS to the USB port of your DiskStation.
2 Tick the Enable UPS support
3 Set the Time before DiskStation enters Safe
Note: If the local UPS is low on battery, or the network UPS server enters Safe Mode, DiskStation will ignore the
specified time period and enter Safe Mode immediately.
4 You can decide whether to send a shutdown signal to the UPS when the system enters Safe Mode. Most UPS
can restore power supply automatically when the power recovers.
5 Click Apply.
When entering Safe Mode, the system will first stop all services and unmount all data volumes to prevent data
loss, so that when the UPS shuts down, the system will be turned off safely. If the Power Recovery function has
been enabled, the system will restart automatically when power is restored.
To enable network UPS support:
1 Tick the Enable UPS support
2 Enter the Network UPS server
3 Set the Time before DiskStation enters Safe
4 Click Apply.
Network UPS support requirements:
 You will need another server connected to an UPS that can be communicated via internet, i.e. a network
UPS server.
 A network device, such as a switch or a hub, should be connected to the same UPS, so that Synology
DiskStation can still communicate with network UPS server during an unexpected power failure.
To enable Network UPS server:
1 Connect a USB UPS to Synology DiskStation.
2 Tick the Enable UPS support
3 Tick the Enable Network UPS Server
4 Enter the IP addresses which will be allowed to connect to Synology DiskStation.
25 Chapter 3: Modify System Settings
(2.5" hard disk mode
will provide better cooling effect, while
checkbox.
Mode.
Term Explanation
checkbox.
IP. (Make sure the server allow connection from Synology DiskStation)
Mode.
More Information
checkbox.
checkbox.
Synology DiskStation User's Guide
(Cool Mode, Lower-Power mode
or 3.5" hard disk mode), depending
Quiet Mode or 2.5" hard disk mode
Based on DSM 4.1
or Quiet