Settings Menu - IBM iLC300 User Manual

Settings menu

To adjust the following Settings options, go to Main Menu -> Settings.
Audio: Allows adjustments to the sound balance between speakers and speaker
volume. The Internal speakers and projector startup Chime can be turned on or off
by placing or removing a check in the respective checkboxes.
Sources -> Power-up Source: This determines which source the projector checks
first for active video during power-up.
Sources: Allows you to assign a particular input to a specific source key as an
optional full-featured remote. Also allows selection of a default Power-up Source
and enables or disables Autosource. When Autosource is not checked, the projector
defaults to the source selected in Power-up Source. If no source is found, a blank
screen displays. When Autosource is checked, Power-up Source determines which
source the projector defaults to at power-up. If no signal is present, the projector
checks the sources in order until a source is found or until power down.
System -> Rear: Reverses the image so you can project from behind a translucent
screen.
Ceiling: Turns the image upside down for ceiling-mounted projection.
Note: It is recommended that all final image adjustments in Ceiling mode are
Auto Power: When Auto Power is checked, the projector automatically goes into
the startup state after the projector is powered on. This allows control of ceiling
mounted projectors with a wall power switch.
Display Messages: displays status messages (such as "Searching" or "Mute") in
the lower-left corner of the screen.
Low Power: Toggles between on and off. Turn it on to lower the light output of the
lamp. This also lowers the fan speed, making the projector quieter.
22
IBM iLC300 Conference Projector: IBM iLC300 Conference Projector User's Guide
made once the unit has fully warmed up.