Displaying A Computer Image - IBM iLC300 User Manual

Service and Support section of our website at www.ibm.com/pc/support.
The projector can be managed by ProjectorNet networking software through its
Network connector.
Network

Displaying a computer image

Use the following steps to display a computer image.
1. Remove the lens cap.
2. Press the Power button on the top of the projector or the remote. The LED
3. Turn on your computer. The computer's image should appear on the projection
4. Make sure your laptop's external video port is active. Many laptops do not
audio in
computer 1 computer 1
audio in
computer in computer in
flashes green and the fans start to run. When the lamp comes on, the startup
screen is displayed and the LED is steady green. It can take a minute for the
image to achieve full brightness. If you do not see a startup screen, see
Appendix B, "Troubleshooting your setup", on page 27.
screen. If it doesn't, press the Computer button on the projector's keypad.
automatically turn on their external video port when a projector is connected.
For IBM machines, press FN+F7 to turn the external display on and off. For
other manufacturers, consult the documentation that came with your computer.
If you do not see a computer image, try pressing the Auto Image button on the
keypad.
video
R
Y
audio in
computer 1 computer 2 computer 2
s-video monitor
network
R
Pr
audio in audio in
L
computer in serial control
audio out audio out
L
Pb
video
R
Y
computer 2 monitor monitor
s-video network
R
Pr
audio in audio in L
serial control
audio out
L
Pb
Chapter 2. Setting up the projector
5