Connecting An Additional Optical Drive, Or Parallel Ata Hard Disk Drive; Connecting A Serial Ata Hard Disk Drive - IBM 8123 User Manual

Connecting an additional optical drive, or parallel ATA hard
disk drive
1. Locate the extra connector on the three-connector signal cable that is attached
2. Connect the extra connector on the signal cable to the new drive.
3. Locate the extra four-wire power connector and connect it to the drive.

Connecting a serial ATA hard disk drive

A serial hard disk drive can be connected to any available SATA IDE connector.
1. Locate the signal cable that comes with the new drive.
2. Locate an available SATA IDE connector on the system board. See "Identifying
3. Connect one end of the signal cable to the drive and the other to an available
4. Locate one of the extra five-wire power connectors and connect it to the drive.
20
User Guide
to the PATA IDE connector on the system board. See "Identifying parts on the
system board" on page 12.
parts on the system board" on page 12.
SATA IDE connector on the system board.
What to do next
v To work with another option, go to the appropriate section.
v To complete the installation, go to "Replacing the cover and connecting the
cables" on page 25.