Using The Grass Bag - Exmark Metro 26 Operator's Manual

Operation
Figure 8
Front Height Adjustment
1. Wheel height adjustment
lever
2. Release the wheel height adjustment lever and
set it securely in the notch.
3. Adjust both front wheels to the same cutting
height setting.
• Rear Wheel Height Adjustment:
1. Pull the rear wheel height adjustment lever
outward towards left wheel and move it to the
same cutting height setting as the front wheels.
2. Release the rear wheel height adjustment lever
and set it securely in the notch.
Figure 9
2. Notches

Using the Grass Bag

Occasionally, you may wish to use the grass bag for
bagging extra long grass, lush grass, or leaves.
• Installing the Grass Bag
1. Stop the engine and wait for all moving parts
to stop.
2. Open the discharge door (Figure 10).
1. Bag support tabs
2. Discharge door
3. Set the bag frame onto the bag support tabs.
4. Lower the discharge door onto the bag.
• Mowing with the Grass Bag
WARNING
A worn grass bag could allow small stones
and other similar debris to be thrown in the
operator's or bystander's direction. Thrown
objects can result serious personal injury or
death to the operator or bystanders.
Check the grass bag frequently. If it is
damaged, install a new Exmark replacement
bag.
Cut the grass until the bag is full.
Note: Do Not overfill the bag.
• Removing the Grass Bag
1. Stop the engine and wait for all moving parts
to stop.
2. Raise the discharge door.
3. Grasp the bag handle and lift the bag off the
lawn mower.
4. Gradually tip the bag forward to empty the
clippings.
5. To install the bag, refer to the Installing the
Grass Bag section.
16
Figure 10
3. Grass bag