Section X: Gasket Replacement - England's Stove Works 13-NCI Installation & Operation Manual

Do not clean the glass with materials which may scratch (or otherwise damage) the glass.
3.
While surface scratches are acceptable, deeper scratches on the glass can develop into
cracks or breaks.
Never attempt to clean the glass while the unit is hot. If the deposit is not very heavy, normal
4.
glass cleaners are adequate with a plain, non-abrasive scouring pad. Heavier deposits may
be removed with the use of an oven cleaner.
NEVER put substances that can ignite explosively inside the unit, since even small explosions
5.
in confined areas can "blow out" the glass.
This unit has an airwash system, designed to reduce deposits on the glass.
6.

SECTION X: GASKET REPLACEMENT

After extensive use, the sealing material which provides glass and door seal may need to be replaced
if it does not sustain its resilience. Inspect the glass and door seal periodically to ensure proper seal.
If the gaskets become frayed or worn, replace immediately. Contact your dealer or Technical support
at (800) 245-6489 for approved replacement parts.
The following steps should be followed for replacement of the glass gasket:
Ensure that the appliance is not in operation, and is thoroughly cooled.
1.
Remove the screws and glass clips.
2.
Lift glass out from glass clips.
3.
Remove the old gasket, and clean the glass.
4.
Replace the new gasket, starting at the bottom of the glass and working along the edges. Be
5.
sure to center the gasket channel on the glass.
Trim the gasket to length and butt the ends together.
6.
Replace the glass in the door, being sure not to over-tighten the screw and clip.
7.
The following steps should be followed for replacement of the door gasket:
Ensure the appliance is not in operation and is thoroughly cooled.
1.
Remove the old door gasket and clean the gasket channel.
2.
Using an approved high-temperature gasket cement, apply a thin coat in the bottom of the
3.
channel.
Starting at the hinge side of the door, work into the channel around the door unit, trim to length
4.
and butt the ends together.
Close the door and allow three to four hours for the cement to set before restarting any fire.
5.
12