Table of Contents
Advertisement
20. Press the Select key and the following message appears:
21. Press the Select key. The system begins loading, and the
following message displays:
22. At this point, DO NOT TOUCH ANY KEYS until the
following message appears:
NOTE: If you do touch some keys during this step, you must
go back to step 9 and start from there again.
23. At the DOS C:\QMSSYS prompt, type the following
command to delete the system and font files from your PC's
hard disk:
Installing System Software from a Macintosh to a
Functional Printer
NOTE: This installation procedure uses the LocalTalk port.
1.
Turn on the printer and wait for IDLE to appear in the message
window.
If the current printer system software is not functioning, see
"Installing System Software and Fonts from a Macintosh to a
Non-Functional Printer," below.
P r i n t e r O p t i o n s
BOOT SYSTEM
HARD DISK
BOOT SYSTEM
HARD DISK 6
BOOT SYSTEM
LOADING
IDLE
del *.dl
Chapter 8
8 - 5 7
Advertisement
Table of Contents
