Adjusting The Sound - Loewe Connect ID 46 Operating Instructions Manual

Connect ID 32-46
Operating instructions
Daily operation

Adjusting the sound

Switching sound off/on
Sound off.
Sound on: Press the button again or increase the volume
using V+.
Setting the volume
V+/V– Volume louder / quieter.
The volume bar will be shown briefly if no other menu
is displayed.
Setting the Sound mode
Call Sound mode.
Sound mode
optimal
Select the number of speakers you want to hear.
Additional sound settings
➠ As long as you can still see the volume bar or the
selection of speakers for sound mode:
Call additional sound settings.
Volume
24
Select sound setting (right column),
go to the menu line below.
Make changes.
Sound settings via the TV menu
➠ In normal TV mode, without other displays.
MENU: Call TV menu.
Select Sound,
go to the menu line below.
Select desired sound setting (right column),
go to the menu line below.
Make changes.
...
Sound mode Dolby PLII mode Sound adjustment
- 34 -
Explanations of the sound settings:
Sound mode Select the number of speakers you want to hear. The
selection depends on the connected sound components
(from page 119) and on the transmitted audio signal.
➠ If the number of speakers appears in brackets, the
sound of missing speakers is transmitted by the exist-
ing speakers (virtual).
optimal The momentarily reproduced audio signal is output with
the ideal number of speakers.
Play centre sound or mono (left/right).
Play front sound (L/R stereo).
Play front and centre sound.
Play front and surround sound.
Play front, surround and centre sound.
Amplifier Play via an external HiFi amplifier. Selection is only
possible if an amplifier has been selected in the sound
components wizard (see page 124).
Dolby PLII Here you can make Dolby Pro Logic II sound settings for
mode movie and music. Menu item only appears with certain
sound mode settings.
Sound Speech, Classical, Pop, Custom music, and Custom
adjustment film sound.
Audio Set the volume of the audio commentary to be relative
commentary to the volume of the programme being transmitted.
volume Should negative values result (those in the area of -50...
-1), the audio commentary is quieter than the programme
sound. Should positive values result (those in the area of
+1... +50), the audio commentary is louder than the
programme sound. If the value 0 results, then the audio
commentary is at the exactly the same volume as the
programme sound.
The menu item only appears if audio commentary is
activated (see page 43) and is offered by the current
station. Additionally, the Loudspeaker sound or Head-
phone sound must be set to normal + audio commentary
must be switched on (see next page).
Headphone Adjust the headphones volume.
volume
Loudness Proper boost of bass and treble tones at low volume.
Sound-picture If the sound does not exactly match the picture, you can
synchronisation correct it here. If you move to the left in the bar you
delay the sound in relation to the picture. If you move
to the right you accelerate it in relation to the picture.
The sound is adapted in time steps of 10ms each.
The Sound-picture synchronisation menu item only ap-
pears for DVB stations.
more ... Call with OK (see next page).