Managing Stations; Tv Stations - Loewe Connect ID 46 Operating Instructions Manual

Connect ID 32-46
Operating instructions

Managing stations

TV stations

Various options for managing stations are available via the TV menu. For
example the description for TV stations. For radio stations the same applies,
except that the Radio menu is called in Radio mode (see also page 56).
➠ Station management is not possible if a programmed timer record-
ing is still pending.
➠ If at least one station is locked the access code must be entered
before Search/Update (see Parental lock on page 60).
Search/update stations – Search wizard
In the search/update with the search wizard, new stations are searched
for which have not yet been stored.
➠ You have to repeat the initial installation (see
page 22) and automatically search for new ones
if you want to delete all the existing stations and
automatically search for new ones.
MENU: Call TV menu.
Select Settings,
go to the menu line below.
Select Stations,
go to the menu line below.
Select Search wizard,
go to the menu line below.
In the upper info text the current search settings will
now be displayed:
SEARCH WIZARD
Your TV carries out the update of the station list (search for new stations; delete
stations no longer broadcast) with the following settings:
Location of TV set
Signal source
TV MENU
Settings
Station
Search wizard
Change search settings
If you want to change these search settings:
Select Change search settings,
OK wizard prompts search settings.
If you agree with these settings:
Select Start search/update,
OK start search.
Red button: Abort current search/update.
- 44 -
United Kingdom
DVB-C
Start search/update
OK
Explanations of some search settings:
Set location Select the country for country-specific defaults and
station sorting.
Signal source Select antenna/cable (analogue), DVB-T, DVB-C or DVB-
S here depending on which signal source you want to
search for new stations.
A configuration of DVB-T and DVB-S antennas can also be
called by the green button (see also page 23 and 24).
➠ Calling up the DVB antenna configuration causes the
Change search settings dialogue to be quit. You must
call up the dialogue again after finishing the config-
uration.
Antenna/cable: With selection of set location the conventional TV
TV/colour standard/colour standard is the default. This should
standard only be changed if stations with other standards are
to be searched.
Encrypted You can state whether coded stations are to be searched
for in the search/update.
stations
are also searched for. However, these stations can only
be received in connection with a CA module and the
appropriate Smart Card.
Card you need to receive certain stations. Handling of
the CA module is described on page 63.
DVB-T If you want to run the station search independently of
the channel grid, select frequency search for the search
Search
method method.
DVB-C With the selection of set location the conventional set-
Settings tings will be preset. Only change this if you know other
symbol rates and modulation types or if you have to
specify the network ID for your cable network (informa-
tion available from your cable network provider).
If you want to run the station search independently of
the channel grid, select frequency search for the search
method.
If you want to run the station search independently of
DVB-S
Settings the channel grid, select frequency search for the search
method.
The symbol rate is specified by the satellite provider and
normally does not need to be adjusted.
Select yes then coded stations
Ask your dealer which Smart