Adjusting The Sound - Loewe Connect 32 3D Operating Instructions Manual

Hide thumbs Also See for Connect 32 3D:
Table of Contents

Advertisement

Daily operation

Adjusting the sound

Switching sound off/on
Sound off.
Sound on: Press the button again or increase the volume
using V+.
Setting the volume
V+/V– Volume louder / quieter.
The volume bar will be shown briefly if no other menu
is displayed.
Setting the Sound mode
Call Sound mode.
Sound mode
optimal
Select the number of speakers you want to hear.
Additional sound settings
➠ As long as you can still see the volume bar or the
selection of speakers for sound mode:
Call additional sound settings.
Volume
24
Select sound setting (right column),
go to the menu line below.
Make changes.
Sound settings via the TV menu
➠ In normal TV mode, without other displays.
MENU: Call TV menu.
Select Sound,
go to the menu line below.
Select desired sound setting (right column),
go to the menu line below.
Make changes.
- 36
...
Sound mode
Dolby PLII mode
Sound adjustment
Explanations of the sound settings:
Sound mode
Select the number of speakers you want to hear. The
selection depends on the connected sound components
(from page 121) and on the transmitted audio signal.
➠ If the number of speakers appears in brackets, the
sound of missing speakers is transmitted by the existing
speakers (virtual).
optimal
The momentarily reproduced audio signal is output with
the ideal number of speakers.
Play centre sound or mono (left/right).
Play front sound (L/R stereo).
Play front and centre sound.
Play front and surround sound.
Play front, surround and centre sound.
Amplifier
Play via an external HiFi amplifier. Selection is only possible
if an amplifier has been selected in the sound components
wizard (see page 126).
Here you can make Dolby Pro Logic II sound settings for
Dolby PLII
mode
movie and music. Menu item only appears with certain
sound mode settings.
Speech, Classical, Pop, Custom music, and Custom film
Sound
adjustment
sound.
Audio
Set the volume of the audio commentary to be relative to
commentary
the volume of the programme being transmitted. Should
volume
negative values result (those in the area of -50... -1), the
audio commentary is quieter than the programme sound.
Should positive values result (those in the area of +1...
+50), the audio commentary is louder than the programme
sound. If the value 0 results, then the audio commentary
is at the exactly the same volume as the programme sound.
The menu item only appears if audio commentary is
activated (see page 45) and is offered by the current
station. Additionally, the Loudspeaker sound or Head-
phone sound must be set to normal + audio commentary
must be switched on (see next page).
Headphone
Adjust the headphones volume.
volume
Loudness
Proper boost of bass and treble tones at low volume.
Sound-picture
If the sound does not exactly match the picture, you
synchronisation
can correct it here. If you move to the left in the bar you
delay the sound in relation to the picture. If you move to
the right you accelerate it in relation to the picture. The
sound is adapted in time steps of 10ms each.
The Sound-picture synchronisation menu item only ap-
pears for DVB stations.
more ...
Call with OK (see next page).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Connect 40 3dConnect

Table of Contents