Table of Contents
Advertisement
Removing the power supply:
Notes:
1. Only IBM-authorized personnel should remove the
power supply.
2. You will need a Phillips head screwdriver for the
following procedure.
1. Complete the procedure, "Removing the logic unit
to install parts" on page 45 before continuing.
2. Disconnect the power supply connector A from
the logic board.
Pinch the top of the power supply connector as you
disconnect it from the logic board. This releases the
power supply connector latch.
3. Remove the two screws B attaching the support
plate C to the power supply D .
4. Pull the support plate C out of the logic unit and
set it aside.
5. Remove the three screws E attaching the power
supply to the logic unit.
6. Push the power supply toward the front of the logic
unit until it stops.
7. Carefully remove the power supply from the logic
unit.
8. Continue with the procedure, "Installing the power
supply" on page 49.
48
Advertisement
Table of Contents
