IBM NetVista N2800e Reference Manual page 48

38
Table 8. NSBxxxx error codes and text messages (continued)
Error code Error message
NSB21500 Audio failure.
Input, keyboard and mouse messages (NSB3xxxx, NSB31xxx, and NSB32xxx)
NSB30500 No input device detected.
NS Boot will continue in
10 seconds.
NSB31500 Keyboard did not
respond.
NSB31510 Keyboard controller did
not respond.
NSB31520 Keyboard was not
recognized.
NSB32500 Mouse did not respond.
NSB40500 USB failure.
NSB40510 USB initialization failure.
CompactFlash card messages (NSB51xxx)
NSB51500 File not found on flash
card.
NSB51510 Cannot close file on flash
card.
NSB62500 Line speed automatic
negotiation failed.
NSB62510 No network device
found.
NSB70500 DHCP, BOOTP, and Local
(NVRAM) network
priority not set.
Most errors associated with DHCP are server configuration errors, contact the system
What you should do
Replace the thin client logic unit (see
"Appendix A. Replacing hardware parts"
on page 41).
Check the keyboard and mouse cable
connections.
Check the keyboard cable connection.
Check the keyboard and mouse cable
connections. If the symptom remains,
replace the thin client logic unit (see
"Appendix A. Replacing hardware parts"
on page 41).
Check the keyboard cable connection.
Check the mouse cable connection.
USB messages (NSB4xxxx)
Disconnect any USB devices from the thin
client and restart the system. If the
symptom remains, replace the thin client
logic unit (see "Appendix A. Replacing
hardware parts" on page 41).
Disconnect any USB devices from the thin
client and restart the system. If the
symptom remains, replace the thin client
logic unit (see "Appendix A. Replacing
hardware parts" on page 41).
Check the contents of the CompactFlash
card.
Check the contents of the CompactFlash
card.
Ethernet messages (NSB62xxx)
Verify that you connected the network
cable to the thin client correctly.
Replace the thin client logic unit (see
"Appendix A. Replacing hardware parts"
on page 41).
Network priority messages (NSB7xxxx)
Verify that at least one network priority is
enabled in the NS Boot utility.
DHCP messages (NSB71xxx)
administrator and report your error.