Chapter 3 Installation Preparation; Front Panel Description; Hardware Description - Zte ZXHN H108N User Manual

Chapter 3 Installation Preparation

3.1 Hardware Description

Front panel
Identification
Power
DSL
Internet
LAN1~LAN4
Figure 3.1-1 Front Panel of the ZXHN H108N
Table 3.1-1 Descriptions of the LEDs on the Front Panel
Color Status
Off
Green/Red Red Flash
Green On
Off
Green Flash
On
Off
Flash
Green/Red
On
Red
Steady on
Green
Flashing
Power off
Software upgrade
Power on
No signals are detected
The MODEM is trying to be in the
activation status
The MODEM has been activated.
The system is under the Bridge mode or
the ADSL has not been connected
There are some data packets passing the
MODEM
The system is under the Route mode and
the ADSL has been connected. The
MODEM IP data packet can be normally
transceiver (For example, the built-in
PPPOE has been established and the
dynamic IP address has been obtained).
Device attempted to become IP connected
and failed (no DHCP response, no PPPoE
response, PPPoE authentication failed, no
IP address from IPCP, etc.)
The LAN connection is established but no
is data transferring.
Data is transmitting.
frequency indicates the LAN traffic.
6
Description
The flashing