Chapter 3 Installation Preparation; Hardware Description - Zte ZXDSL 831B User Manual

Chapter 3 Installation Preparation

3.1 Hardware Description

Front panel
LED No. Color
Power Green/Red
DSL Green
Internet* Green
Ethernet Green
Note*: The Internet LED is only effective for the ZXDSL 831/831II equipment
Power
Figure 3.1-1 Front Panel of the ZXDSL 831/831B/831II/831BII
Table 3.1-1 Descriptions of the LEDs on the Front Panel
Status
Off Shutdown
Red Flash Software upgrade.
Green On Power on
No signals are detected
Off
Flash The MODEM is trying to be in the activation status
On The MODEM has been activated.
The system is under the Bridge mode or the ADSL has
Off
not been connected
There are some data packets passing the MODEM
Flash
The system is under the Route mode and the ADSL has
been connected. The MODEM IP data packet can be
On normally transceived (For example, the built-in PPPOE
has been established and the dynamic IP address has
been obtained).
The Ethernet interface is in the non-communication
Off
status
Flash Data is received or sent on the Ethernet interface
On The Ethernet interface is in the communication status
DSL Internet Ethernet
7
Note