Zte ZXHN H108N User Manual page 16

4. Connect Ethernet port of the Gateway with 10/100BASE-T port of the
computer using the network cable that comes with the modem.
5. Plug in the power cord, and turn on the power.
If you don't want Internet services and telephone voice services simultaneously,
please just connect the LINE port of the Gateway with the RJ-11 port (the
phone jack) on the wall using a telephone cord. In this case, the splitter is not
necessary.
Connection procedures
1 Power off the equipment before all the other devices are connected.
2 Connect the network cables: Insert the RJ-45 Ethernet cable connector
into the Ethernet interface of the ZXHN H108N, and connect its other
terminal to the Ethernet adapter of the customer computers or ports of other
network devices.
3 Connect the splitter
The splitter has three interfaces, which are described as follows:
 LINE: Connect the user telephone cable (RJ11 interface).
 MODEM (or ADSL): Connect the DSL interface of the ZXHN H108N.
 PHONE (or TEL): Connect the phone sets.
The installation process is as follows: Connect the LINE interface of the
ZXHN H108N to the MODEM(or ADSL) interface of the splitter using the
RJ-11 telephone cable, connect the phone set lines to the PHONE(or TEL)
interface of the splitter, and then connect the user telephone cable port to the
LINE interface of the splitter.
4 Connect the power
Connect one terminal of the power adapter to the POWER interface of the
ZXHN H108N, and the other terminal to the socket on the wall, and then
switch on the power of the ZXHN H108N equipment.
Checking all connection cables
ZXHN H108N User's Manual
9