IBM High Performance Storage System HPSS Installation Manual page 285

; Default Time Out = 1500
# Specify (in octal) the Default umask
; Default Umask = 077
# Specification of the Level of HPSS Client API logging to use ( 0 - 3
)
; Client API Verbose Value = 0
# Do NOT allow the user to specify Classes of Service (HPSS Only)
; Disallow User Setting of COS
# Name the Kerberos Keytab file for "Kerberized" PFTP Daemon (HPSS
Only)
; Keytab File Name = /etc/v5srvtab
# Name of the Realm associated with the PFTP Daemon (HPSS Only)
; HPSS RealmName = realm.com
# Specify to make the Client API use the port range specified
; Use Port Range
# Specification in seconds for the Maximum Timeout
; Maximum Time Out = 86400
# Disallow the use of TCP
; Use UDP ONLY
# Use the Extended Registry Attributes if they Exist (HPSS.conf)
; Use Extended Registry Attributes
# Print additional Performance Numbers (non-HPSS PFTP Daemon Only)
; Print Performance Data
# Specify the Maximum Stripe Width Allowed (non-HPSS PFTP Daemon Only)
; Number of Ports = 16
# Port to be used for the PDATA_PUSH Protocol. (HPSS Only)
; IOR Listen Port = 19199
# The Port Range to be used for the non-HPSS Parallel FTP Daemon
# which is necessary for Parallel Transfers (non-HPSS PFTP Daemon
Only)
; PortRange = ncadg_ip_udp[10100-12100]:ncacn_ip_tcp[10100-12100]
# The Socket Buffer Size (non-HPSS PFTP Daemon Only)
; Socket Buffer Size = 1MB
# Uncomment next line to use the COS from the FileSize Options
# The default is to ignore the COS specification in the Table.
; Set COS Based on Filesize
# Specify Blocksizes, StripeWidths, and COSs to use based on file size
# COS has no meaning to the Non-HPSS PFTP Daemon
# COS = 0 means allow the BitFile Server to determine the optimal COS
# BlockSize has no meaning to the HPSS PFTP Daemon Only
# StripeWidth = 0 means use the Bitfile Server Value (HPSS PFTP
Daemon)
# or use the default (Non-HPSS PFTP Daemon)
; FileSize Options = {
# Files greater than or equal to this value and less than
# any other value in the table use these Settings
# e.g., 2MB <= filesize < 10MB
; 1MB = {
; BlockSize = 512KB
; StripeWidth = 0
; COS = 2
; }
; 2MB = {
; BlockSize = 2MB
; StripeWidth = 4
; COS = 0
; }
; 10MB = {
; BlockSize = 2MB
; StripeWidth= 0
; COS = 0
; }
HPSS Installation Guide
Release 6.2 (Revision 2.0)
(RPC_SUPPORTED_PROTSEQS=ncadg_ip_udp)
July 2008
285