IBM High Performance Storage System HPSS Installation Manual page 280

SubStanza
SubStanza
SubStanza
SubStanza
(Compound)
Section
(Compound)
SubSection
SubSection
HPSS Installation Guide
Release 6.2 (Revision 2.0)
PortRange = <value>
E.g. PortRange =
ncadg_ip_udp[10100-12100]:ncacn_ip_tcp[10100-12100]
Optional SubStanza specifying the port range to be used for the non-HPSS
parallel FTP daemon which is necessary for parallel transfers. NOTE:
This is ignored for passive listings, etc.
Socket Buffer Size = <value>
Vlaues: Viable Socket Sizes
E.g. Socket Buffer Size = 1MB
Optional SubStanza specifying the socket buffer size. (non-HPSS PFTP
daemon only.)
Set COS Based on Filesize
Values: Pathname/filename
E.g. Set COS Based on Filesize
Optional SubStanza specifying to set the COS from the FileSize Options
table. Default: Ignore the COS in the table.
FileSize Options = {
E.g. FileSize Options = {
Optional SubStanza specifier.
Must be terminated with a matching "}"
See notes below.
<value> = {
E.g. 1MB = {
Optional Section specifier.
Must be terminated with a matching "}"
See notes below.
BlockSize = <value>
E.g. BlockSize = 512KB
Optional SubSection specifying the size of data blocks to be used based on
file size. (Has no meaning for the HPSS PFTP daemon.)
StripeWidth = <value>
E.g. StripeWidth = 0
Optional SubSection specifying the stripe width to be used based on file
size. 0 means use the Core Server Value (HPSS PFTP daemon) or use the
default (Non-HPSS PFTP daemon).
July 2008
280