IBM High Performance Storage System HPSS Installation Manual page 214

Option 1 – Rename old tables
[ renaming LSPOLICY table to PRE62_LSPOLICY ]
[ renaming SERVER table to PRE62_SERVER ]
[ renaming DMG table to PRE62_DMG ]
[ renaming GATEKEEPER table to PRE62_GATEKEEPER ]
[ renaming MOVERDEVICE table to PRE62_MOVERDEVICE ]
[ renaming SITE table to PRE62_SITE ]
Option 2 – Create new tables
Note: This option uses the hpss_managetables program which will assist in creating the newly
formatted HPSS 6.2 tables.
Execute the following commands to complete this step:
db cfg
add LSPOLICY
add SERVER
add DMG
add GATEKEEPER
add MOVERDEVICE
add SITE
add SERVERINTERFACES
add AUTHZACL
db subsys1
add DMGFILESET
commit
quit
Option 3 – Convert Gatekeeper config table
[ converting PRE62_GATEKEEPER to GATEKEEPER ]
Option 4 – Convert Location Server policy table
[ converting PRE62_LSPOLICY to LSPOLICY ]
Option 5 – Convert Server Generic config table
[ converting PRE62_SERVER to SERVER ]
Option 6 – Convert DMG config table
[ converting PRE62_DMG to DMG ]
Option 7 – Convert Mover Device table
[ converting PRE62_MOVERDEVICE to MOVERDEVICE ]
This ends the process for converting HPSS 5.1 specific metadata. Proceed with Section 6.3.17:
Perform the DCE Export: hpss_dce_export on page 215 to continue with the conversion to HPSS
6.2.
HPSS Installation Guide
Release 6.2 (Revision 2.0)
July 2008
214