Carrier 59SP5A Installation, Start-Up, Operating And Service And Maintenance Instructions page 70

reach 32_F (0_C) or lower unless winterized. Follow these
procedures to winterize your furnace:
CAUTION
!
UNIT COMPONENT DAMAGE HAZARD
Failure to follow this caution may result in damage to the
furnace and other property damage.
Do not use ethylene glycol (automotive antifreeze coolant or
equivalent). Failure of plastic components may occur.
1. Obtain propylene glycol (RV/swimming pool antifreeze or
equivalent).
2. Turn off gas and electrical supplies to your furnace.
3. Remove furnace control door.
4. Remove the top unused rubber plug from the port on the
collector box opposite the condensate trap. See Fig 57.
5. Connect a field supplied 3/8- -in. (9.5- -mm) ID tube to the
open port on the collector box.
6. Insert a field supplied funnel into the tube.
7. Pour 1 quart of anti- -freeze solution into the funnel/tube.
Antifreeze should run through the inducer housing, overfill
condensate trap and flow to an open drain.
8. Replace the rubber plug in the port on the collector box.
9. Remove the middle unused rubber plug from the port on the
collector box opposite the condensate trap. See Fig. 57.
10. Repeat Steps 5 through 8.
11. If a condensate pump is used, check with pump manufacturer
to verify pump is safe for use with antifreeze used. Allow
pump to start and pump anti- -freeze to open drain.
12. Replace main door.
13. When furnace is re- -started, flush condensate pump with clear
water to check for proper operation before re- -starting furnace.
14. Propylene glycol need not be removed before re- -starting
furnace.
1-1/4-in.
(31.8)
2-1/2-in.
(64.4)
Fig. 55 - - Igniter Position - - Top View
Fig. 56 - - Igniter Position - - Side View
Fig. 57 - - Priming Condensate Trap
A11405
Fig. 58 - - Cleaning Heat Exchanger Cell
Manifold
70
2-in.
3/8-in.
3/16-in.
(2.5 mm +/- .75 mm)
Burner Flame
Burner
Fig. 59 - - Burner Flame
.
A11272
A11392
A11273
A11461