Accessories; Loose Parts Bag; Minimum Clearances To Combustible Materials - Carrier 59SP5A Installation, Start-Up, Operating And Service And Maintenance Instructions

NOT move or shuffle your feet, do not touch ungrounded
objects, etc.).
4. If you touch ungrounded objects (and recharge your body
with static electricity), firmly touch a clean, unpainted metal
surface of the furnace again before touching control or
wires.
5. Use this procedure for installed and uninstalled (ungroun-
ded) furnaces.
6. Before removing a new control from its container, discharge
your body's electrostatic charge to ground to protect the
Qty
1 Air Intake Pipe Flange
1 Vent Pipe Flange
2 Coupling Flange Gaskets
10 Sharp Tip Screws (Vent and Inlet Flanges)
1 Vent Pipe Coupling
2 Vent Pipe Coupling Clamps
1 Pressure Switch Tube
1 Outlet Choke Plate (used with 40k BTUH furnaces, only)
1 Drain Tube Elbow
1 Drain Extension Tube
2 Drain Tube Clamps
1 Drain Line Grommet
1 Gas Line Grommet
1 Gas Line Knockout Plug
1 Junction Box Cover
1 Junction Box Base
1 Green Ground Screw
3 Blunt Tip Screws (Junction Box)
1 Thermostat Wire Grommet
POSITION
FRONT (Combustion air openings in furnace and in structure)
Required for service
All Sides of Supply Plenum
Top of Furnace
*Recommended
Table 1 – Loose Parts Bag Contents (Provided in blower compartment)
Table 2 – Minimum Clearances to Combustible Materials for All Units
REAR
Sides
Vent
control from damage. If the control is to be installed in a
furnace, follow items 1 through 4 before bringing the con-
trol or yourself in contact with the furnace. Put all used and
new controls into containers before touching ungrounded
objects.
7. An ESD service kit (available from commercial sources)
may also be used to prevent ESD damage.

ACCESSORIES

See Product Data Sheet for a list of accessories for this product.
Description
CLEARANCE
1 in. (25 mm)
*24 in. (610 mm)
1 in. (25 mm)
1 in. (25 mm)
5
0
0
0