Power Save Configuration Menu - Cisco 7975G Software Manual

Cisco Unified IP Phone Settings
Option
Wideband Handset
Enterprise
Advertise G.722
Codec
Device Advertise
G.722 Codec

Power Save Configuration Menu

The Power Save Configuration menu displays the settings that control the LCD phone screen turning off to
conserve power. The following table describes the options on this menu.
For detailed information about these settings, see
Description
Indicates whether wideband is
enabled or disabled for the handset.
Default: "Use Phone Default" on
Cisco Unified Communications
Manager Administration. (This
default means that the phone will
be enabled for a wideband handset
only if the phone was shipped with
a wideband handset.)
Enables/disables (enabled by
default) Cisco Unified IP Phones
to advertise the G.722 codec to
Cisco Unified Communications
Manager. For more information,
see the Cisco Unified
Communications Manager System
Guide, "Cisco Unified IP Phones"
chapter, "Codec Usage" section.
When a phone is
Note
registered with a Cisco
Unified Communications
Manager that does not
support this setting, the
default is "Disabled."
Allows you to override the
Enterprise Advertise G.722 Codec
on a per-phone basis.
The default is "Use System
Default," which means the value
configured for the Enterprise
Advertise G.722 Codec parameter
gets used.
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Power Save Configuration Menu
To change
If Wideband Handset UI Control is enabled, you
or the user can choose
> Audio Preferences > Wideband Handset.
If Wideband Handset UI Control is disabled, use
Cisco Unified Communications Manager
Administration and choose Device > Phone >
Phone Configuration to set this value.
Note If you allowed this option to be user
controllable (in the Wideband Handset
UI Control option), the user-configured
value takes precedence.
From Cisco Unified Communications Manager
Administration, choose System > Enterprise
Parameters.
From Cisco Unified Communications Manager
Administration, choose Device > Phone.
EnergyWise Setup on Cisco Unified IP Phone, on page
Communications Manager 9.0 (SCCP and SIP)
> User Preferences
157.
99