Power Save Configuration Menu - Cisco 7971G-GE - IP Phone VoIP Administration Manual

Device Configuration Menu
Table 4-13 Media Configuration Menu Options (continued)
Option
Enterprise Advertise
G.722 Codec
Device Advertise G.722
Codec

Power Save Configuration Menu

The Power Save Configuration menu displays the settings that control when the LCD screen on a phone
turns off to conserve power.
For detailed information about configuring these settings, see the
Unified IP Phone Touchscreen" section on page
Table 4-14 Power Save Configuration Menu Options
Option
Display On Time
Display On Duration
Display Idle Timeout
Days Display Not
Active
Display On When
Incoming Call
Cisco Unified IP Phone 7970G/7971G-GE Administration Guide for Cisco Unified Communications Manager 7.0
4-22
Description
Enables/disables Cisco Unified IP Phones to
advertise the G.722 codec to Cisco Unified
Communications Manager. If enabled (default),
and if each endpoint in the attempted call supports
G.722 in its capabilities set, Cisco Unified
Communications Manager will choose G.722
for the call.
When a phone is registered with a Cisco
Note
Unified Communications Manager that
does not support this setting, the default
is "Disabled."
Allows you to override the Enterprise Advertise
G.722 Codec on a per-phone basis.
The default is "Use System Default," which
means the value configured for the Enterprise
Advertise G.722 Codec parameter gets used.
Table 4-14
Description
Time each day that the LCD screen turns on
automatically (except on the days specified in
the Days Display Not Active field).
Length of time that the LCD screen remains on
after turning on at the time shown in the Display
On Time option.
Length of time that the phone is idle before the
display turns off. Applies only when the display
was off as scheduled and was turned on by an
end-user (by pressing a button on the phone,
touching the touchscreen, or lifting the handset).
Days that the display does not turn on
automatically at the time specified in the
Display On Time option.
Indicates whether the LCD screen automatically
illuminates when a call is received.
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
To Change
From Cisco Unified Communications Manager
Administration and choose System >
Enterprise Parameters.
From Cisco Unified Communications Manager
Administration and choose Device > Phone.
describes the options on this menu.
6-7.
To Change
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
"Automatically Disabling the Cisco
OL-15299-01