In-Use Phone Protocol To Protocol Conversion; Deploy Phone In Sccp And Sip Environment; Cisco Unified Ip Phone Mac Address Determination - Cisco 7975G Software Manual

Cisco Unified IP Phones and Telephony Networks
b) To provision the phone by using the Bulk Administration Tool (BAT), choose the appropriate phone model
and choose SIP from the BAT.
c) To provision the phone manually, make the appropriate changes for SIP on the Phone configuration window
in Cisco Unified Communications Manager Administration.
For more information about Cisco Unified Communications Manager Administration, see the Cisco Unified
Communications Manager Administration Guide. For more information about BAT, see the Cisco Unified
Communications Manager Bulk Administration Guide.
Step 2
If you are not using DHCP in your network, configure the network parameters for the phone.
Step 3 Save the configuration updates and perform the following:
a) Click Apply Config.
b) When the Apply Configuration Information window displays, click OK.
c) Power cycle the phone.
Related Topics
Network Settings, on page 58

In-Use Phone Protocol to Protocol Conversion

For information on how to convert an in-use phone from one protocol to the other, see the Cisco Unified
Communications Manager Administration Guide, "Cisco Unified IP Phone Configuration" chapter, "Migrate
existing phone settings to another phone" section.

Deploy Phone in SCCP and SIP Environment

To deploy Cisco Unified IP Phones in an environment that includes SCCP and SIP and in which the Cisco
Unified Communications Manager autoregistration parameter specifies SCCP, perform these general steps:
Procedure
Step 1
Set the Cisco Unified Communications Manager auto_registration_protocol parameter to SCCP.
Step 2 From Cisco Unified Communications Manager, choose System > Enterprise Parameters.
Step 3 Install the phones.
Step 4 Change the Auto Registration Protocol enterprise parameter to SIP.
Step 5
Autoregister the SIP phones.

Cisco Unified IP Phone MAC Address Determination

Several of the procedures in this manual require you to determine the MAC address of a Cisco Unified IP
Phone. You can determine the MAC address for a phone in any of these ways:
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
In-Use Phone Protocol to Protocol Conversion
Communications Manager 9.0 (SCCP and SIP)
41