Types 8307, 8308, 8310, 8311, 8314, and 8315
To remove the system board, do the following:
1. Turn off the server and peripheral devices and disconnect all external cables
2. See "Types 8307, 8308, 8310, 8311, 8314, and 8315" on page 80
3. Disconnect all wires connected to the system board.
4. Remove the six screws that attach the system board to the chassis.
5. Lift out the system board.
Replacing the cover, Types 8301 and 8302
After replacing parts, you need to replace the cover and reconnect cables, including
telephone lines and power cords. Also, depending on the option that is installed,
you might need to confirm the updated information in the IBM Setup Utility
program. To replace the cover and connect cables to the computer:
1. Ensure that all components have been reassembled correctly and that no tools
2. Clear any cables that might impede the replacement of the cover.
and power cords; then, remove the cover. See "Types 8307, 8308, 8310, 8311,
8314, and 8315" on page 41.
or loose screws are left inside the computer.
Important:
Before replacing the cover, ensure that these cable routing measures are
adhered to:
Chapter 6. FRU Removals
83