IBM 8302 Hardware Maintenance Manual page 60

3. Remove the metal shield from the drive bay by inserting a flat-blade
4. Make sure the drive is set correctly as the master device. Refer to the
5. Pivot the drive bay latch handle toward the front of the computer and then
6. Install the drive into the bay. Align the screw holes and insert the two screws.
7. Each integrated drive electronics (IDE) drive requires two cables; a four-wire
54
Hardware Maintenance Manual
screwdriver into one of the slots and gently prying it loose.
documentation that comes with your CD-ROM drive or DVD-ROM drive for
master/slave jumper information.
pivot the drive bay cage upward, as shown, until it is latched in the up
position.
power cable that connects to the power supply, and a signal cable that connects
to the system board.
To connect a CD-ROM drive or DVD-ROM drive to your computer, follow
these steps:
a. Locate the signal cable that comes with your computer or with the new
drive.
b. Locate the secondary IDE connector on the system board. See "Identifying
parts on the system board" on page 44.
c. Connect one end of the signal cable to the secondary IDE connector on the
system board and the other to the CD-ROM drive or DVD-ROM drive.