IBM 8302 Hardware Maintenance Manual page 68

4. Remove the metal shield from the drive bay by inserting a flat-blade
5. Make sure the drive that you are installing is set correctly as either a master or
6. Install the drive into the bay. Align the screw holes, and insert the screws that
7. Each integrated drive electronics (IDE) drive requires two cables; a four-wire
62
Hardware Maintenance Manual
screwdriver into one of the slots and gently prying it loose.
a slave device.
v If it is the first CD drive or DVD drive, set it as a master device.
v If it is an additional CD drive or DVD drive, set it as a slave device.
v If it is a hard disk drive, set it as a slave device.
Refer to the documentation that comes with your drive for master/slave
jumper information.
secure the drive to the bay.
power cable that connects to the power supply and a signal cable that connects