Sym ATTILA RS-21 EFi 150 Service Manual page 33

2. Maintenance Information
Brake Lining Wear
The indent mark on brake lining is the wear
limitation.
Replace the brake lining if the wear limit mark
closed to the edge of brake disc.
Caution
It is not necessary to remove brake hose
when replacing the brake lining.
Remove the brake clipper bolt, and take out the
clipper.
Caution
Do not operate the brake lever after the
clipper removed to avoid clipping the brake
lining.
Pry out the brake lining with a flat driver if lining
be clipped.
Remove brake lining bolt.
Take out the lining.
Caution
In order to maintain brake power balance, the
brake lining must be replaced with one set.
Brake Lamp Switch
The brake lamp switch is to lit up brake lamp as
brake applied.
Make sure that electrical starter can be operated
only under brake applying.
2-12
This chapter Contents
Brake
clipper bolt
Brake lining
Brake lining
wear limit
Brake clipper Brake disc
Bolt
Master
cylinder
Brake lamp
switch