Removal Of Engine Suspension Bushing; Removal Of Engine - Sym ATTILA RS-21 EFi 150 Service Manual

This chapter Contents

5. REMOVAL OF ENGINE

Removal Of Engine Suspension
Bushing
If engine suspension frame and the cushion
rubber of rear shock absorber bushing damaged.
Then, with the bushing remover / pressor,
Ø 28mm & Ø 20mm, to press the bushing out,
and replace it with new one.
Engine suspension bushing: Ø 28mm
Rear shock absorber bushing: Ø 20mm
Pressing out
Place the detent section of the bushing remover
toward the bushing, and drive both the pressing
ring and bolt in to press the bushing out.
Pressing In
Place the flat section of the remover toward the
bushing, and then drive the bushing, pressing
ring, and bolt in to install the bushing.
5-7