Sym ATTILA RS-21 EFi 150 Service Manual page 12

¡ E Do not let the wire harness contact with
rotating, moving or vibrating components as
routing the harness.
¡ E Keep wire harnesses far away from the hot
parts.
•
Route wire harnesses to avoid sharp edges or
corners and also avoid the projected ends of
bolts and screws.
¡ E Route harnesses so that they neither pull too
tight nor have excessive slack.
NEVER TOO
TIGHT
This chapter Contents
1. General Information/Trouble Diagnosis
¡ E Protect wires or wire harnesses with electrical
¡ E Secure the rubber boot firmly as applying it on
NEVER TOUCH
¡ E Never use wires or harnesses which insulation
¡ E Never clamp or squeeze the wire harness as
tape or tube if they contact a sharp edge or
corner. Thoroughly clean the surface where
tape is to be applied.
wire harness.
has been broken. Wrap electrical tape
around the damaged parts or replace them.
installing other components.
Never clamp or
squeeze the wire
harness
1-7