Finishing Commissioning - Worcester GREENSTAR 24i junior Instruction Manual

A
A
C
C
36

FINISHING COMMISSIONING

B
B
C
INSTALLATION & SERVICING INSTRUCTIONS FOR WORCESTER GREENSTAR 24 i junior/28 i junior
The boiler has been factory set, so there should be no
need to adjust any controls.
1. REPLACE OUTER CASING:
Replace outer casing making sure that the securing
points are properly located.
Replace top two screws (A).
Retighten bottom two screws (B).
2. FITTING FASCIA FLAP:
Present the flap up to the appliance with the hinge pins
facing the appliance.
Engage the left hand pin into the grey pivot. The hinge
pin and pivot hole are both square, rotate the flap to
ensure that the pin is located in the pivot.
Support the flap in your left hand and with your right
hand, bend the right side down. This should enable
you to engage the right hand pin in the pivot. Rotate
the flap to ensure that the pins and pivots are located
securely.
Close the flap.
3. INSTALLING BOTTOM PANEL:
The bottom panel slides onto two ledges (C) either
side of the boiler frame.
Hold the panel up against the underside of the boiler
and slide towards the rear until it is fully engaged.
NOTE: Every time the power to the appliance is
HANDOVER:
Complete the Benchmark Gas Boiler Commissioning
Checklist.
NOTE: The Benchmark Checklist can be found at the
Open the fascia cover by gently pressing the
centre top of the cover (D).
Set up the controls and show the user how to
operate all the controls shown in the User Guide.
Place the user guide into the tray (E) on the inside of
the fascia cover.
If the appliance is unused and exposed to freezing
conditions, shut off all the mains supplies and drain the
C
system and boiler.
E
FINISHING COMMISSIONING
turned off and on, the appliance enters a
learning mode and may take some
time to optimise the boiler performance.
This time is variable and is dependant on
hot water and central heating demand.
rear of these instructions.
D
8 716 115 166a (06/2008)