Finishing Commissioning - Worcester GREENSTAR 35 CDi Installation, Commissioning And Servicing Instructions

5.7

FINISHING COMMISSIONING

The boiler has been factory set, so there should be no need to adjust
combustion settings.
REPLACE OUTER CASING:
1. Replace outer casing making sure that the securing points are
properly located.
▶ Press the clip (A) downwards to secure casing on top.
▶ Retighten bottom two screws (B).
INSTALLING BOTTOM PANEL:
2. The bottom panel slides onto two ledges (C) either side of the boiler
frame.
▶ Hold the panel up against the underside of the boiler and slide
towards the rear until it is fully engaged.
HANDOVER:
▶ Complete the Benchmark check list.
▶ The fascia cover is opened by pulling the flap (D) towards you.
▶ Set up the controls and show the user how to operate all the controls
shown in the User Guide.
▶ Place the user guide into the tray (E) on the inside of the facia cover.
▶ If the appliance is unused and exposed to freezing conditions; shut off
all the mains supplies and drain the system and boiler.
A
Fig. 53 Fitting outer case
6 720 812 175 (2014/07)
B
B
6720647361-25.3Wo
D
Fig. 54 Fitting bottom panel
COMMISSIONING
C
6720647361-26.3Wo
35