Entry/Exit Delays; General Information; Exit Delay Alert Sound - ADT SA10ADTEG User Manual

General Information

Your system has preset time delays, known as exit delay and entry delay. When you arm
your system, the exit delay gives you time to leave through the designated entry/exit
door(s) without setting off an alarm.
The Main entry delay gives you time to disarm the system when you re-enter through
the designated main entry/exit door. The Secondary entry delay will have been
assigned to another type of entry (check with your installer). The system must be
disarmed before an entry delay period ends, or an alarm will occur. The touchpad will beep
slowly during the entry delay period, reminding you to disarm the system.
You can also arm the system with no entry delay at all by using the INSTANT arming mode.
This mode can provide greater security while you are sleeping, but should be used with
care since an alarm will result if any entry/exit or perimeter protection point is violated
(door, window, etc., is opened).
Your Exit and Entry Delay times are as follows:
Exit Delay When arming AWAY (see page 18), slow beeps will sound from the touchpad during the
Alert Sound exit delay, reminding you to exit. These turn to fast beeps during the final five seconds of
the exit time.
These beeps may be silenced by pressing any key on the touchpad after arming.

ENTRY/EXIT DELAYS

Exit Delay: 6 0 seconds
– 12 –
Main Entry Delay:
Secondary Entry Delay:
Remember, there will be no entry delay when
arming INSTANT.
4 5 seconds
1 0 seconds