Paging Feature - ADT SA10ADTEG User Manual

If the paging feature has been programmed, a pager will respond to certain conditions as they occur in your system by
displaying a 7-digit system status code that will indicate the type of condition that has occurred. In some cases, the 7-digit
code may be preceded by 16 digits, which can consist of a PIN number, Subscriber account number, or any additional data
that you may wish to have sent to the pager in addition to the 7-digit system status code.
The entire pager display format is as follows:
Optional 16 digits
A = Optional 16-digits for Account numbers, PIN numbers, or any other data. This information must be programmed by
the installer.
B = A 3-digit code that describes the event that has occurred in your system (see explanation for event codes below).
C = A 4-digit User or Zone number, depending on the type of event that has occurred. For alarms and troubles, these
digits represent the zone number. For openings (disarming) and closings (arming), these digits represent the user
number. In this system, the first 2 digits will always be "00" (e.g., 0004 will be displayed for zone number 4). Note
that single-digit user or zone numbers are always preceded by a zero.
The 3-digit Event Codes (BBB) that can be displayed are:
911 = Alarms. The 4-digit number (CCCC) following this code will be the zone number that has caused the alarm.
811 = Troubles. The 4-digit number (CCCC) following this code will be the zone number that has caused the trouble.
101 = Open (system disarmed). The 4-digit number (CCCC) that follows this code will be the user number.
102 = Close (system armed). The 4-digit number (CCCC) that follows this code will be the user number.
Examples of typical pager displays follow. Not included in the examples below are the optional 16 digits (preceding the
7-digit status code) that may have been programmed by the installer for additional data.
Example 1 Pager displays:
.
Example 2. Pager displays:

PAGING FEATURE

3-digit Event Code
AAAAAAAAAAAAAAAA – BBB – CCCC
-
91 1–0 00 4
= S ystem is reporting an alarm (911) caused by a fault on zone 4 (0004).
10 2–0 00 5
= S ystem is reporting a closing–system arming (102) by user 5 (0005).
– 25 –
[
4-digit User or Zone No.
=