Manually Initiating A Fire Alarm - ADT SA10ADTEG User Manual

FIRE ALARM SYSTEM (Continued)
Manually Initiating 1. Should you become aware of a fire emergency before your detectors sense the
a Fire Alarm problem, go to your nearest Touchpad and manually initiate an alarm by pressing the
appropriate panic key(s), assigned for FIRE emergency. Check below, and in the
PANIC KEYS section.
2. Evacuate all occupants from the premises.
3. If flames and/or smoke are present, leave the premises and notify your local Fire
Department immediately.
4. If no flames or smoke are apparent, investigate the cause of the alarm. The zone
number(s) of the zone(s) in an alarm condition will be displayed at the Touchpad.
The following lettered key, or key pair (depending on the type of touchpad), has been
assigned for manually initiating a FIRE alarm. Verify this with your installer.
CUSTOM DISPLAY TOUCHPAD
Press
same time.
DISPLAYS FOLLOWING MANUAL INITIATION OF A FIRE ALARM
FIRE 95
CUSTOM DISPLAY TOUCHPAD
KEY ASSIGNED FOR FIRE
A for 2 seconds. Press
– 3 0 –
ENGLISH DISPLAY TOUCHPAD
KEY PAIR ASSIGNED FOR FIRE
1 and
AC
95
ALARM
FIRE
ENGLISH DISPLAY TOUCHPAD
at the